24
EN
Basic photography
2
Using a fl ash (fl ash photography)
1
Slide the fl ash switch to raise the fl ash.
2
Press the # button (I) to display options.
3
Use HI to choose a fl ash mode and press Q.
• The options available and the order in which they are displayed vary depending on
the shooting mode. g “Flash modes that can be set by shooting mode” (P. 25)
AUTO Auto fl ash
The fl ash fi res automatically in low light or
backlight conditions.
!
Red-eye reduction fl ash
This function allows you to reduce the red-
eye phenomenon.
#
Fill-in fl ash
The fl ash fi res regardless of the light
conditions.
$
Flash off The fl ash does not fi re.
!SLOW
Slow synchronization/
Red-eye reduction fl ash
Combines slow synchronization with red-eye
reduction.
#SLOW
Slow synchronization
Slow shutter speeds are used to brighten
dimly-lit backgrounds.
#FULL,
#1/4 etc.
Manual For users who prefer manual operation.
4
Press the shutter button all the way.
# Cautions
• In [!(Red-eye reduction fl ash)], after the pre-fl ashes, it takes about 1 second before the
shutter is released. Do not move the camera until shooting is complete.
• [!(Red-eye reduction fl ash)] may not work effectively under some shooting conditions.
To Next Page
Loading...
