1
O.M.A.C. s.r.l.
Via Giovanni Falcone, 8 42048 Rubiera (RE) - Italy Tel.0522/629371 - 629923 Fax 0522/628980
E-mail:info@omacpompe.com SitoWeb:www.omacpompe.com
Rev.4 del 01/2010 O.M.A.C. s.r.l.
Chap.7 - pag.
CHAPTER 7: B SERIES LDPU SPARE PARTS
Throughout his life, the LDPU may require the replacement of consumed or worn parts. To simplify the recognition of its consumption elements, O.M.A.C.
S.r.l. completes this manual with specifi cations defi ned for the identifi cation of spare parts.
They are mainly spare parts that, if required, must be replaced only by skilled technical personnel authorised by O.M.A.C.
WARNING
Only skilled personnel authorised by O.M.A.C. S.r.l. can carry out extraordinary maintenance replacement interventions, performing the replacement
interventions of the components described below.
Do not try to replace parts without authorisation.
In case of replacing constructive mechanical parts that compose the LDPU, some of these need long manufacture time that can take a few months.
It is advisable to have enough of the components described above in the amounts deemed necessary to limit machine down time.
DANGER
Only skilled personnel authorised by O.M.A.C. s.r.l. can carry out extraordinary maintenance interventions; do not try to replace parts of the machine if
unauthorised. O.M.A.C. s.r.l. is not liable for damages to persons, animals or things deriving from unauthorised interventions.
7.1 List of spare parts and section drawings of the lobe displacement pump
Below the LDPU will be presented in its various sizes, complete with exploded view construction drawing and bill of materials table.
For each component, the tables below indicate the position in the exploded view drawing, the description, the needed amount and, depending on the
model, the item code to order as spare part.
In the “amounts” column there may be one or more values present: where there are two amounts, the value marked with the asterisk only refers to the
code marked with an asterisk, present on the same line, with reference to the pump model that one possesses.
AVVERTENZA
If, to replace spare parts, one needs to remove the front cover of the pump (pos. 44), it is essential to restore the pump hygiene level before putting it
back into service. It is reminded that in case the “B series lobe pump” has been confi gured for the treatment of alimentary products, level 1 hygiene must
be ensured.
To Next Page
Loading...
