Possibili cambiamenti senza preavviso!
D846MGB -Rev. 04 3/14
1 General information before installation
1.1 Description of the terminology
Homelift valve
Main control valve
EM valve
Manual emergency valve
EVD
Descent solenoid valve
EVR
Flow adjusting solenoid valve
PM
Hand pump
1.2 Description and operating principle
The Homelift control unit C40-C50 is in
accordance with the Machinery Directive 2006/
42/ EC.
Depending on the configurations required as
options, it will also comply with the European
standards EN81-2:1998 and A3:2009 in
accordance with the Lift Directive 95/16/EC and
standard EN81-41.
1.3 Responsibility and warranty
These instructions have been written for people
with experience of installing, adjusting and
maintaining hydraulic lifts.
OMARLIFT is not liable for harm caused by
improper use or use other than that prescribed in
these instructions or by the inexperience or
carelessness of the persons assembling,
adjusting or repairing the lift’s hydraulic
components.
OMARLIFT’s warranty is also voided if different
components or non-original spare parts are
installed, if unauthorised changes or repairs are
carried out or are carried out by non-qualified or
unauthorized persons.
Unless otherwise stated, the following activities
are prohibited for technical safety reasons:
- any type of change to the product;
- installation of the product for other purposes
than those described;
- damage to any seal;
- incorrect or improper maintenance or
inspections;
- the use of unsuitable accessories, spare parts
or operating material that are not approved by
OMARLIFT or are not original OMARLIFT spare
parts;
1.4 Health and Safety Warnings
In the course of these instructions the important
health and safety points will be marked by the
following symbols:
General hazard warning
High hazard risk warning. Risk of personal
injury (e.g. crushing, cutting edges,
protruding parts, etc.)
Risk of damage to components (for
example incorrect installation or the like).
Important information symbol, important
notice.
Risk of electric shocks (exposed parts
carrying live voltage).
In addition to the instruction manual, you must
comply with generally applicable national
standards, standards, rules and other standards
governing health, safety and the protection of the
environment and special operating conditions
such as the use of a lift and work equipment (e.g.
company processes or transport of personnel).
Installation and repair technicians are the first
people to be responsible for their own safety.
This Instruction Manual applies to the entire life of
the system/product from installation, during
normal operation; from the tests until
maintenance; it is an integral part of the system
and must be kept in a protected and accessible
place by the installation technician.
To Next Page
Loading...
Need help?
General