Why is my Omcan SP200AT Mixer motor temperature high and speed reduced?
There are several reasons why the motor temperature might rise while the output speed is reduced: * Too low voltage: Check the power supply. * Over-loaded: Reduce the load. * The speed of mixing is too high, or wrong attachment is being used, or mixing too long: Select a suitable speed and attachment and reduce the load.
What to do if my Omcan SP200AT planetary does not rotate after starting?
If the planetary does not rotate after starting the machine, the cause may be loose electric wiring. Check the electric wiring and tighten any loose connections. Press the reset button.
Why is my Omcan SP200AT Mixer leaking oil?
Oil leakage in your Omcan Mixer usually indicates that the seal rings are worn out and need replacement.
What to do if my Omcan Mixer bowl lift is difficult to pull up?
If the bowl lift on your Omcan Mixer is difficult to pull up, it is likely that the guide rails are not lubricated. Lubricate the guide rails to resolve this issue.
What to do if the Omcan SP200AT makes abnormal noise and the gearbox has a high temperature?
Abnormal noise and high temperature from the gearbox usually indicate insufficient lubrication. Add or replace the grease.
What to do if the Omcan SP200AT Mixer attachment knocks with the bowl?
If the mixing attachment knocks with the bowl, it is likely that the attachment or bowl is deformed. Repair or replace the attachment or bowl.
Steps for uncrating, proper placement, and safe electrical connection of the mixer.
Procedures for safe operation, power requirements, and speed adjustment.
Step-by-step instructions for attaching and detaching the mixer bowl.
Guide for installing attachments onto the VFM10B, focusing on notch alignment.
General| Model | SP200AT |
|---|---|
| Category | Mixer |
| Motor Power | 1 HP |
| Speed Settings | 3 |
| Voltage | 110V |
| Frequency | 60 Hz |
| Type | Planetary |
| Bowl Capacity | 20 quarts |
| Power | 750 W |
To Next Page
