Why is my Omcan VFM10B Mixer motor temperature high and speed reduced?
There are several reasons why the motor temperature might rise while the output speed is reduced: * Too low voltage: Check the power supply. * Over-loaded: Reduce the load. * The speed of mixing is too high, or wrong attachment is being used, or mixing too long: Select a suitable speed and attachment and reduce the load.
What to do if my Omcan VFM10B planetary does not rotate after starting?
If the planetary does not rotate after starting the machine, the cause may be loose electric wiring. Check the electric wiring and tighten any loose connections. Press the reset button.
Why is my Omcan VFM10B leaking oil?
Oil leakage in your Omcan Mixer usually indicates that the seal rings are worn out and need replacement.
What to do if my Omcan VFM10B Mixer bowl lift is difficult to pull up?
If the bowl lift on your Omcan Mixer is difficult to pull up, it is likely that the guide rails are not lubricated. Lubricate the guide rails to resolve this issue.
What to do if the Omcan VFM10B makes abnormal noise and the gearbox has a high temperature?
Abnormal noise and high temperature from the gearbox usually indicate insufficient lubrication. Add or replace the grease.
What to do if the Omcan VFM10B Mixer attachment knocks with the bowl?
If the mixing attachment knocks with the bowl, it is likely that the attachment or bowl is deformed. Repair or replace the attachment or bowl.
Crucial safety precautions and general notes for operating the mixer.
Identifies and explains the controls and switches specific to the VFM10B model.
Identifies and explains the controls and switches specific to the SP200AT model.
General| Model | VFM10B |
|---|---|
| Category | Mixer |
| Capacity | 10 Qt |
| Power | 0.5 HP |
| Speeds | 3 |
| Material | Stainless Steel |
To Next Page
