Why is my Omcan Mixer motor temperature high and speed reduced?
There are several reasons why the motor temperature might rise while the output speed is reduced: * Too low voltage: Check the power supply. * Over-loaded: Reduce the load. * The speed of mixing is too high, or wrong attachment is being used, or mixing too long: Select a suitable speed and attachment and reduce the load.
What to do if my Omcan SP200A Mixer planetary does not rotate after starting?
If the planetary does not rotate after starting the machine, the cause may be loose electric wiring. Check the electric wiring and tighten any loose connections. Press the reset button.
Why is my Omcan Mixer leaking oil?
Oil leakage in your Omcan Mixer usually indicates that the seal rings are worn out and need replacement.
What to do if my Omcan SP200A Mixer bowl lift is difficult to pull up?
If the bowl lift on your Omcan Mixer is difficult to pull up, it is likely that the guide rails are not lubricated. Lubricate the guide rails to resolve this issue.
What to do if the Omcan SP200A Mixer makes abnormal noise and the gearbox has a high temperature?
Abnormal noise and high temperature from the gearbox usually indicate insufficient lubrication. Add or replace the grease.
What to do if the Omcan SP200A Mixer attachment knocks with the bowl?
If the mixing attachment knocks with the bowl, it is likely that the attachment or bowl is deformed. Repair or replace the attachment or bowl.
Inspect shipments for damage and report issues to the carrier promptly.
Covers uncrating, location, electrical connections, and initial operation checks.
Details the on/off switch and features for the VFM10B model.
Explains the on/off switches and timer for the SP200AT model.
Describes the on/off buttons for the SP200A model.
Outlines controls including timer and speed lever for SP300AT.
Covers on/off buttons and speed lever for the SP300A model.
Step-by-step guide for attaching and detaching bowls for all models.
Procedure for installing and removing attachments for the VFM10B model.
Instructions for fitting and removing mixer attachments for SP200AT/SP200A.
Guide for attaching and detaching attachments for SP300AT/SP300A models.
Form fields for the user to provide their personal and purchase details.
To Next Page
General