4
Installation
Technical Specications
UNCRATING
Immediately after uncrating the mixer, check for possible shipping damage. If the machine is found to be
damaged after uncrating, save all packaging materials and contact the carrier within 3 days of delivery. Failure
to contact the carrier or supplier in a timely fashion may cause you a loss.
LOCATION
Prior to installation, test the electrical service to assure that it agrees with the specications on the machine’s
rating plate. Place the mixer on a sturdy and level surface. There should be adequate space around the mixer
for the user to operate the controls and to install and remove the bowls. Holes are located in the base to
permanently secure the mixer, although this is not necessary in normal installations.
ELECTRICAL CONNECTIONS
The electrical cords on these machines are equipped with a three-pronged grounding plug, which must be
connected to a properly grounded receptacle. If the receptacle is not properly grounded, contact an electrician.
DO NOT remove the grounding prong from the plug. Electrical and grounding connections must comply with
the applicable regulations and local electrical codes.
Check Initial Operation
1. Install the bowl and raise into the mix position, with the bowl support up and bowl safety guard closed.
2. Apply power to the mixer by inserting the cord plug into a properly grounded outlet.
3. Turn the Speed Lever to position 1.
4. Run the machine by pushing the START and then the STOP buttons.
Name
Bowl
Volume
Power
(KW)
Volts Hertz Nema
Weight
(Kg)
Speed of Planetary
Shaft (r/min)
Overall Dimensions
(mm)
1st
Speed
2nd
Speed
3rd
Speed
VFM10 10 L 0.5 110V 60 5-15 75 108 195 355 485 x 410 x 635
SP200A 20 L 1.1 110V 60 5-15 90 108 195 355 600 x 600 x 780
SP300A 30 L 1.5 110V 60 5-20 180 91 166 282 700 x 620 x 1200