Omcan SP200A User Manual

8
Operation Instructions
Installing Mixer Attachments - VFM10B
Ensure machine is off, lower bowl to loading position. Keep note of the notch on the shaft (Fig.3) and raise the
attachment over the shaft. (Fig.4) Turn the attachment to the left until you can turn no more (Fig.5) and release,
the attachment should now dip down a bit and lock in place. To Remove the attachment, follow the instructions
above in reverse order.
Installing Mixer Attachments - SP200AT / SP200A
Ensure machine is off, lower bowl to loading position. Open the Guard by pulling the handle away from
the magnetic latch. (Fig.6) Raise the attachment over the shaft, keeping note of where the notch is. (Fig.7)
Guide the notch through the path until it reaches the end and locks. (Fig.8) To remove attachment, follow the
instructions above in reverse order.
Fig.3
Fig.4 Fig.5
Fig.6 Fig.7 Fig.8
SP300AT / SP300A
Fig.2

Omcan SP200A Specifications

General

Brand	Omcan
Model	SP200A
Category	Mixer
Language	English