7
Operation Instructions
Installing Mixer Bowls - All Models
1. Place the bowl on the two arms to keep it in place. Insert the bowl pin into pin support located on frame.
Carefully align holes on the bowl with the studs on the bowl arms. (Fig.1)
2. Once the bowl is seated properly, swing the locking levers into position. (Fig.2)
3. To remove the bowl, follow the instructions above in reverse order.
Fig.1
VFM10B / SP200AT / SP200A
1
2
3
On/Off Switch - SP300A
Features:
• On Button
• Off Button
• Speed Adjusting Lever with Handle
To Next Page
Loading...
