Foldover clasps
Specific sections/general information4
Adjusting the length (fig. 3):
free the longer section from the
two slideways (A) and from the
catch (B). Adjust the bracelet in
the required direction and rein-
sert in the catch and the two
slideways. Try the watch for size
and readjust if necessary.
fig. 1
fig. 2
Only
OMEGA
straps, specially designed for this foldover clasp,
should be used. For your own peace of mind and convenience, we
recommend that you have your new clasp fitted by an authorised
OMEGA
service centre. You can always adjust the length of the
bracelet yourself.
Opening (fig. 1): to open the clasp, press the two pushers
on either side of the
OMEGA
buckle and pull upwards.
Closing (fig. 2): put the watch on your wrist and close the clasp
by pushing on it with your thumb until you hear a click. (fig. 2).
fig. 3
Using the rotating bezel (fig. 4)
: keep the pusher A pressed down
to turn the bezel.
Using the crown (fig. 4): the crown B must be unscrewed before it
can be used, when the crown protection C will slide without turning.
After use, push the crown to position 1, then press and screw the crown
down again (to ensure the water resistance of the case).
Note: the crown is located at 9 o’clock, but its functions are identical.
Using the fine length adjuster (fig. 5)
Using the diving extension (fig. 6)
Note: to fold the diving extension away, it is important to proceed
according to fig. 6.2 (with the diving extension perpendicular to the
cover of the clasp).
Ploprof bezel and crown
Specific sections/general information4
fig. 4
fig. 5
fig. 6
fig. 6.1 fig. 6.2 fig. 6.3
B
A
A
01-OMEGA_V14-I_EN.indd 40-41 16/05/12 14:01:21
To Next Page
Loading...
