18
Manual & self-winding watch
Operating instructions2
Occasional winding: if the watch has not been worn for
55 hours or more, wind it up with the crown in position 1.
2. Annual calendar: pull the crown out to position 2. Turn the
crown forwards to change the date or backwards to change the
month. Push the crown back to position 1.
Note: the day following 28 or 29 February (depending on
whether it is a leap year), the date needs to be adjusted by one
or two days (crown in position 2). Ideally, the date should be
adjusted after setting the time. When correcting the date between
midnight and 10 am, the effort required for the first jump is
slightly greater than for the others.
NB: do not exit correction mode until the displays (date and
month) are centred in the aperture.
Calibres 8922, 8923
Do not switch out of correction mode unless the date is centred
in the window and the month hand centred in the month display.
3. Time setting: hours – minutes – seconds. Pull the crown out to
position 3, the seconds hand will stop. Turn the crown forwards or
backwards. Synchronise the seconds by pushing the crown back to
position 1 to coincide with a given time signal.
NB: when changing the date backwards in time setting mode, it
is necessary to wind the hands back to noon to ensure the date
changes.
The crown has 3 positions:
1. Normal position (wearing position): when the crown is
positioned against the case, the crown ensures that the watch is
water-resistant.
CALIBRES 8602, 8612 (fig. III)
ê
ê
To Next Page
Loading...
Need help?
General