Manual & self-winding watch
Operating instructions2
Occasional winding: if the watch has not been worn for 55 hours
or more, wind it up with the crown in position 1.
2. Correcting the date: pull the crown out to position 2. Turn the
crown forwards to change the date or backwards to change the day.
Push the crown back to position 1.
NB: do not quit setting mode if the displays (day and date) are not
properly centred in their windows.
3. Time setting: hours – minutes – seconds. Pull the crown out to
position 3. The seconds hand will stop. Turn the crown forwards or
backwards. Synchronise the seconds by pushing the crown back to
position 1 to coincide with a given time signal.
NB: when setting the day and date backwards in setting mode, it
is necessary to go back to 2 pm to ensure that the day and date
change at the right time.
The crown has 3 positions, but only positions 1 and 3 are functional
for the jewellery version of the calibre 1120 (fig. I).
1. Normal position (wearing position): when the crown is
positioned against the case, the crown ensures that the watch is
water-resistant.
Occasional winding: if the watch has not been worn for
48 hours or more (calibres 8800 and 8801: 55 hours, calibres 8520,
8521, 8700, 8701, 8704, 8705: 50 hours, calibre 1120: 44 hours,
calibre 2520: 40 hours), wind it up with the crown in position 1.
CALIBRE 2300
(fig. X)
CALIBRE 2627
(fig. V)
CALIBRES 8704, 8705 (fig. XI)
8521, 8700, 8701, 8800, 8801
CALIBRES 1120, 2500, 2507, 2520, 2610, 8520, (fig. I)
ê
ê
To Next Page
Loading...
Need help?
General