Omega CN76000 - Page 23

21
CONFIGURACONFIGURA
CONFIGURACONFIGURA
CONFIGURA
TION CHARTION CHAR
TION CHARTION CHAR
TION CHAR
T (cont'd)T (cont'd)
T (cont'd)T (cont'd)
T (cont'd)
CnF6CnF6
CnF6CnF6
CnF6
AcPtAcPt
AcPtAcPt
AcPt
id ##id ##
id ##id ##
id ##
FACtFACt
FACtFACt
FACt
dFLtdFLt
dFLtdFLt
dFLt
CONFIGURACONFIGURA
CONFIGURACONFIGURA
CONFIGURA
TION CODETION CODE
TION CODETION CODE
TION CODE
DISPLADISPLA
DISPLADISPLA
DISPLA
YY
YY
Y
MENU ITEMMENU ITEM
MENU ITEMMENU ITEM
MENU ITEM
0 = No Alar m
1 = Close at SP1 = Close at SP
1 = Close at SP1 = Close at SP
1 = Close at SP
,,
,,
,
LED LED
LED LED
LED
flashing flashing
flashing flashing
flashing
2 = Open at SP, LED flashing
3 = Close at SP, LED off
4 = Open at SP, LED off
Accept
Configuration
no = Retain old Configuration. Press ENTER to exit.
YES = Accept Configuration. Press ENTER to exit.
Factor y Identification. Not for customer use.
Factor y default. Defaults Configur ation to f actor y codes
sho wn in boldf ace type in the char t above.
WW
WW
W
arning:arning:
arning:arning:
arning: The Hardware Configuration will be
cleared and must be re-entered using the
Hardware Configur ation code f ound on the
Model / Ser ial label located on the top of the
instr ument housing. The configuration menu cannot be
exited until v alid Hardware codes are entered.
If f actor y default is desired, sim ultaneously press the
ENTERENTER
ENTERENTER
ENTER &
DODO
DODO
DO
WN ARRWN ARR
WN ARRWN ARR
WN ARR
OO
OO
O
WW
WW
W keys.
Alar m State
SPECIFICASPECIFICA
SPECIFICASPECIFICA
SPECIFICA
TIONSTIONS
TIONSTIONS
TIONS
SelectabSelectab
SelectabSelectab
Selectab
le Inputs:le Inputs:
le Inputs:le Inputs:
le Inputs: Thermocouple, R T D, current or v oltage .
Input Impedance:Input Impedance:
Input Impedance:Input Impedance:
Input Impedance:
Thermocouple = 3 megohms minimum. R TD current = 200 uA.
Current = 249 ohms. Voltage = 5000 ohms.
Sensor Break PrSensor Break Pr
Sensor Break PrSensor Break Pr
Sensor Break Pr
otection:otection:
otection:otection:
otection: De-energizes control outputs to protect system.
Loop Break PrLoop Break Pr
Loop Break PrLoop Break Pr
Loop Break Pr
otection:otection:
otection:otection:
otection: Error message is initiated upon shor ted sensor or open heater
circuit. Break time is adjustable from OFF to 9999 seconds.
Loop Break Alarm:Loop Break Alarm:
Loop Break Alarm:Loop Break Alarm:
Loop Break Alarm: If equipped with an Alar m relay, the Alar m m a y be prog rammed to
operate upon a loop break.
Set PSet P
Set PSet P
Set P
oint Rangoint Rang
oint Rangoint Rang
oint Rang
e:e:
e:e:
e: Selectable.
DisplaDispla
DisplaDispla
Displa
ys:ys:
ys:ys:
ys: Tw o 4 digit, 7 segment 0.3" high LEDs . Process V ar iab le red, Set V ar iab le g reen.
ContrContr
ContrContr
Contr
ol Action:ol Action:
ol Action:ol Action:
ol Action: Reverse (usually heating), Direct (usually cooling) selectable f or single or
dual set point models.
PrPr
PrPr
Pr
oporopor
oporopor
opor
tional Band:tional Band:
tional Band:tional Band:
tional Band: 6 to 5000 °F or equiv alent °C for temperature inputs . 6 to 9990 counts
for current or v oltage inputs .
Reset Reset
Reset Reset
Reset
Time (Integral):Time (Integral):
Time (Integral):Time (Integral):
Time (Integral): Off or 0.1 to 99.9 min utes .
Rate Rate
Rate Rate
Rate
Time (DerivTime (Deriv
Time (DerivTime (Deriv
Time (Deriv
ative):ative):
ative):ative):
ative): Off or 0.01 to 99.99 min utes .
CycCyc
CycCyc
Cyc
le Rate:le Rate:
le Rate:le Rate:
le Rate: 2 to 80 seconds ,
ApprAppr
ApprAppr
Appr
oacoac
oacoac
oac
h Rate:h Rate:
h Rate:h Rate:
h Rate: Off to 99.99 min utes .
On - Off DiffOn - Off Diff
On - Off DiffOn - Off Diff
On - Off Diff
erential:erential:
erential:erential:
erential: Adjustable 2 °F to full scale in 1° steps (equiv alent °C), or 2 counts
to full scale in 1 count steps f or current and voltage inputs .
Alarm On - Off DiffAlarm On - Off Diff
Alarm On - Off DiffAlarm On - Off Diff
Alarm On - Off Diff
erential:erential:
erential:erential:
erential: 2 °F or equiv alent in °C , or 2 counts .
Scaling fScaling f
Scaling fScaling f
Scaling f
or Current or or Current or
or Current or or Current or
or Current or
VV
VV
V
oltaolta
oltaolta
olta
gg
gg
g
e Inputs:e Inputs:
e Inputs:e Inputs:
e Inputs: Adjustable for a maximum negative to positiv e