PROGRAMMING THE ECHO
TO
THE SECURITY SYSTEM
The Echo must be programmed to the system in order to operate it. This programming procedure
is
identical for a I-way transmitter or Echo transceiver. The original I-way transmitters may be used
to also operate the security system, in addition to the Echo.
To
program all, follow this procedure:
Have all
of
the transmitters or transceivers at hand (when one is programmed, all others are erased).
Step 1 Tum the vehicle's ignition "on".
Step 2 Within5seconds
of
turning"on"the ignition, presstheValetSwitch5times. Thesirenwill
chirp once, confirming that the system is ready to learn an Echo or I-way transmitter.
Step 3 Within I0secondspressandreleasethe"ArmlLock"button(the"lockedpadlock"graphic).
The siren will chirp once, confirming that the system learned the Echo or transmitter.
Step 4 Repeat the previous step for each Echo or transmitter which is to operate the system.
• The system will remove itselffrom the programming mode
if
10 seconds expire without its
receiving a signal,
if
the ignition is turned
"off',
or upon four transmitters or transceivers
being programmed into the system.
• Only the "Arm/Lock" button is pressed in programming; when it is learned all
of
the other
buttons' functions are automatically assigned.
Page
-10
PROGRAMMING THE ECHO
TO
THE SECURITY SYSTEM
The Echo must be programmed to the system in order to operate it. This programming procedure
is
identical for a I-way transmitter or Echo transceiver. The original I-way transmitters may be used
to also operate the security system, in addition to the Echo.
To
program all, follow this procedure:
Have all
of
the transmitters or transceivers at hand (when one is programmed, all others are erased).
Step 1 Tum the vehicle's ignition "on".
Step 2 Within5seconds
of
turning"on"the ignition, presstheValetSwitch5times. Thesirenwill
chirp once, confirming that the system is ready to learn an Echo or I-way transmitter.
Step 3 Within I0secondspressandreleasethe"ArmlLock"button(the"lockedpadlock"graphic).
The siren will chirp once, confirming that the system learned the Echo or transmitter.
Step 4 Repeat the previous step for each Echo or transmitter which is to operate the system.
• The system will remove itselffrom the programming mode
if
10 seconds expire without its
receiving a signal,
if
the ignition is turned
"off',
or upon four transmitters or transceivers
being programmed into the system.
• Only the "Arm/Lock" button is pressed in programming; when it is learned all
of
the other
buttons' functions are automatically assigned.
Page
-10
To Next Page
Loading...