22
7 E
RROR
C
ODES
The following error messages are displayed under certain error conditions:
Err2 Err2 Internal memory checksum error. Memory corruption.
Contact Omega.
“- - . -” “- - - - -” Hi-Lo, 0.5 Hz* Temperature out of maximum instrument limits or no signal
Err5 Argument out of range
Err6 Unrecognized command
*: The exact analog output behavior is a function of the command “o”; see previous Chapter.
Note that these error codes are not applicable when using the FOB100-SOFT software package. This high-
level software package is programmed to automatically handle all types of errors, as outlined in the next
section.
To Next Page
Loading...
