24
You should normally see a window similar to this:
In this example, we see that FOB100-SOFT has detected 2 thermometers: a FOB104 and a HHTFO
instruments.
FOB100-SOFT is now properly installed and ready to use!
8.2.1 Working with the Configuration Window
FOB100-SOFT starts with the “Acquisition” window active, as shown in the figure above. To switch to the
“System Configuration” window, you need to click on one of the instrument names that have been detected;
for example, by clicking on “Omega FOB”, you will get the following window:
To Next Page
Loading...
