13
IF THE AUGER STOPS WORKING
2
1
[REV]
[ON/OFF]
Press [Rev] button for 3 to 5 seconds,
then release. When the [Rev] button is
released, the auger will stop rotating.
Repeat this 2 to 3 times.
The [Rev] button pushes the ingredients
upward releasing the food clog.
Press [ON/OFF] button and select a speed
to start. When using [ON] or [REV] button,
make sure the auger stops completely
after stopping or releasing the button.
Note:
Even after following the directions above,
if the juicer still doesn’t work, please
unplug the power cord, disassemble the
chamber set and clean it. Then try again.
[LO/HI]
To Next Page
Loading...
