9
Installation Instructions
INSTALLATION OF BUILT-IN OVEN
Insert the oven into cabinet partly by pushing it forward. Open the oven door and insert 2 screws
into the holes on the oven frame. While the product frame touches the wooden surface of the
cabinet, tighten the screws.
If the oven is installed below a built-in hob, the distance between the worktop and the top panel of
the oven must be a minimum of 50mm, and the distance between the worktop and the top of the
oven control panel must be a minimum of 25mm. The front of the oven will remain in front of the
cabinet.
The dimensions and material of the cabinet in which the oven will be installed must be correct and
resistant to increases in temperature. In a correct installation, contact with electrical or insulated
parts must be prevented. Insulating parts need to be fitted in a way to ensure that they cannot be
removed by using any kind of tool.
Installing the appliance in the close vicinity of a refrigerator or a deep-freezer is not recommended
as the performance of the above-mentioned appliances will be negatively affected due to
emanating heat. After removing your oven from its packaging, be sure that the oven is not
damaged. If you suspect any damage to the appliance, do not use it; immediately contact an
authorised Service Centre.
INSTALLATION IN AN ELEVATED CABINET
INSTALLATION UNDER A BENCHTOP
To Next Page
Loading...
