14
OPERATING INSTRUCTIONS
Using Gas Burners
The flame cut-off safety device (FFD); operates instantly when the safety mechanism
activates due to overflown liquid over the upper hobs.
1. The valves controlling the gas cookers have a special security mechanism. To light the cooker, hold down
the switch and turn it counterclockwise. All of the lighters will operate and the cooker you are controlling will
light. Keep the switch pressed until the cooker ignites.
2. Do not continuously operate the igniter for more than 15 seconds. If the burner does not ignite, wait a
minimum of one minute before trying again.
3. In models with the gas security system, when the flame of the cooker is extinguished, a control valve cuts off
the gas automatically. To operate the burners with the gas security system you must press the knob and turn
counter-clock-wise. After the ignition you must wait approximately 5-10 seconds for the gas security system
to activate. If the burner is extinguished for any reason, close the gas control valve and wait a minimum of
one minute before trying again.
4. Closed Fully open Half open
5. Before operating your hob please make sure that the burner caps are well positioned. The right placement of
the burner caps are shown below.
To Next Page
Loading...
