Product User Guide | 7
OM-CP-OCTPRO
USER INTERFACE
Channel Configuration
When the Channel Configuration icon is selected, the device will display the screen shown below
• Channel 1-8: Configures the type of channel input,
units, engineering units (if applicable), alarms and user
calibration adjustments.
• Update: Applies the current channel configuration to make
the device ready to start logging or display real-time data.
• File: Loads previously saved channel configurations.
• Save: Saves the current channel configuration so it may
be loaded and used later.
• Disable All: Clears the configuration of all channels,
returning them to the default disabled status.
• Cancel: Cancels changes and then goes back to the
Home screen.
Select Channel Configuration
Channel Setup
When the user selects a Channel, the device will display the Channel Setup screen with several options.
• Disable (Channel is not being used)
• RTD (RTD probe)
• TC (Thermocouple probe)
• Voltage
• Current
• Thermistor (Thermistor probe)
• Pulse (Only available on channel 1)
Select Channel Configuration Select Channel
To Next Page
Loading...
