Omega Omegalink OL-RS-FO1 - MODULE PROGRAMMING PROCEDURE (2 KEYS)

U.S. Patent No. 8,856,780
>>
01
OFF
ACC ON
START
02
OFF
ACC ON
START
03
04
OFF
ACC ON
START
05
OFF
ACC ON
START
06
OFF
ACC ON
START
07
OFF
ACC ON
START
08
09
10
OFF
ACC ON
START
11
OFF
ACC ON
START
12
OFF
ACC ON
START
13
14
15
OFF
ACC ON
START
16
>>
MODULE PROGRAMMING PROCEDURE (2 KEYS) - 1 OF 2
NOTE: To complete this procedure, both OEM
keys are required.
Insert key 1 into ignition.
Turn key 1 to ON position. LED will turn solid
RED.
Wait, LED will fl ash GREEN. (This may take up
to 30 seconds)
Turn key 1 to OFF position.
Remove key 1.
Insert key 1 into ignition.
Turn key 1 to ON position.
If LED turns solid GREEN for 2 seconds:
Module Programming Procedure completed.
If LED turns solid RED, proceed with following
step.
TIME RESTRICTION. Complete steps 08 to 10
within 4 seconds after LED turns OFF.
Remove key 1.
Insert key 2 into ignition.
Turn key 2 to ON position.
Wait, LED will turn solid RED then will turn
OFF.
TIME RESTRICTION. Complete steps 13 and 14
within 4 seconds after LED turns OFF.
Remove key 2.
Press and release programming button.
If the LED begins to fl ash RED, you are using a
cloned key or used the same key twice.
Automotive Data Solutions Inc. © 2016 OEMFORSFO1BOLRSFO1EN
PAGE 15 OF 24
• 20160224
DOC.: #26841