APPLIANCE DETAILS
ELECTRICAL DETAILS:
This information can be found on the rating plate (data label) affixed to the inside of the door jamb.
SIZES:
ELECTRICAL CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by a licensed electrician, and carried out according to
instructions provided by the manufacturer. Incorrect installation might cause harm and
damage which the manufacturer accepts no responsibility.
ELECTRICAL INSTALLATION FOR THE LICENSED ELECTRICIAN
This oven must be connected to a 220-240V 50Hz power supply.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage, and
the mains electric wiring should be suitable for the oven’s power rating (also indicated on the appliance
identification plate);
The switched outlet must be connected to a suitable earth wiring, in conformity to current safety regulations.
This appliance must be plugged into a 10A switched outlet. It should not be located above the appliance and
no more than 1.25m away from it. The power supply cord must not touch any hot surfaces and must be placed
so that its temperature does not exceed 75°C at any point along its length. After having installed the appliance,
the switched outlet must always be in an accessible position.
NOTE: For connections to the mains power supply, never use adapters, reductions or multiple power points as
these may overheat and catch fire.
The mains terminal block is located on the back of the oven and the terminals are accessible by opening the
terminal block cover.
Note: The terminal cover should not be opened when the mains power is still connected to the appliance and
never by an unauthorized person.
The electrical safety of this appliance can only be guaranteed if the oven is correctly and efficiently earthed. The
manufacturer declines all responsibility for damage resulting from an installation which has not been earthed
correctly. The use of adapters, multiple sockets and/or extensions, is not allowed.
To Next Page
Loading...
