CLEANING
SAFETY PRECAUTION
Before cleaning your rangehood or performing any maintenance, please ensure that the range hood is turned off
at the power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy water and a cloth are
recommended.
Ensure that the range hood is cleaned regularly, as a build-up of grease and fat may occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and prevent grease build up. The
filter mesh is made of metal. It is recommended that this is undertaken every 4 – 6 weeks, depending on frequency
of use. The filters can be cleaned with warm soapy water or a cloth.
Cleaning of the range hood must be performed as described above, otherwise there is a possibility of a fire hazard
due to grease and fat build up.
REPLACING THE LAMPS
1) Before changing the lights, make sure that the appliance is unplugged from the power source and lamps are
cool.
2) Open the filter and twist the face of the lamp anti-clockwise to disengage the lamp.
3) Change the GU-10 40W halogen lamp.
4) Replace the filter to the original position.
TROUBLESHOOTING
Light on, but motor
does not work
Select a fan switch position.
Contact Service Department.
Contact Service Department.
work, motor does
not work
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the air ventilation entrance
are not tightly sealed
Take down the one way valve and seal with
sealant.
Leakage from the connection of U-shaped
section and cover
Take U-shaped section down and seal.
Contact Service Department.
The distance between the range hood and the
gas top is too far
Refit the range hood to the correct distance.
The fixing screw not tight enough
Tighten the hanging screw and make it
horizontal.
To Next Page
Loading...
Need help?
General
