Omega PL402XA - Turning On and Starting a Cycle; Changing or Adding Dishes During Cycle; End of Wash Cycle Procedures

It is d ange ro u s to ope n t he door w hen was hi ng , be c a use the hot wate r ma y s cal d y ou .
W h en t h e working cy cle h as fini s hed, the buz zer o f t he di s hwa she r wi ll s o u nd for 8 seco n d s , th en s top . Tu r n o ff
t he a ppliance usi ng th e O N/O FF b utto n, sh ut off t he wa ter s upply and op en t he d oor of t he di shwashe r.
Wait for a f ew m inutes bef ore unlo ading th e dis hwash er t o av oid ha ndlin g th e dishes and ut ensils wh ile th ey
are still h ot a nd m ore suscept ible to br eak age. They w ill als o dr y be tter.
Switch Off the Dishwasher
After t he program has ended:
1.Sw itch off t he di shwasher by p ressin g t he ON/OF F button.
2.Turnoff thewater tap!
Open the door carefully.
Hot di shes are sensitive t o kn ocks. The dishes should therefor e b e all owed t o cool d own ar ound 15 minutes
before removingfrom the appliance.
Open t he d ishwasher 's door, leave it a jar and w ait a few m inutes before rem oving t he dishes. I n this way they
will be cooler and the drying will b e im proved.
Unloading the dishwasher
It i s norm al t hat t he di shw ashe r is wet in side.
Empty the low er ba sket first a nd then t he up per o ne. T his will avoid water dripping from t he upper Bas ket onto
the dishes in the l ower one.
A forgott en dish can be added at any time before the detergent cup opens.
Load the forgotten dishes.
Close the door, the dishwasher will start running again
after 10 seconds.
After the spray arms stop working,you can open the door
completely.
2
Open the door a little to stop the washing.
1
3
4
t he machi ne wi ll workin g a fter 1 0 seconds.continue
I f you ope n t he doo r , the mach ine w ill paus e. W hen you cl ose the door ,during a w ash cycle
Dr aw out the l ower an d up per b asket, load the d ishes an d pu sh t hem bac k.
It iscommendedtoloadthelowerbasketfirst,thentheupperone(seethe sectionentitled
Lo adi n g the Di shwa she r ) .
P our in th e de tergent ( see the secti on e ntitled Salt , De tergent and Rins eAi d ) .
I nser t the plu g in to t he soc ket. The pow er s uppl y is 2 40 VA C /50 HZ, t he s pec ifica tion of th e
sock et is 10A 250 VAC. Make sure that the wat er su pply is turne d on to f ull p ressure.
Clo se the doo r, pr ess the O N/OFF butt on, a nd t he d isplay wi ll lig ht up . Turn th e knob t o sel ect
a desired washcycle, and pressSTART/Reset button, the machine will work.
“”
“”
1
2
3
4
P remise:
A cycle that i s und erwa y ca n onl y be m odifi ed if it ha s on ly been r unning for a shor t
ti me. Otherw ise, t he d etergent may h ave a lread y be en re leas ed, and th e ap pliance m ay
hav e alr ead y dra ined t he w ash wate r. If th is is the c a se, t he d etergent di spenser must
be refill ed (se e th e sect ion entit led " Load ing th e De tergent " ).
Press START/RESET button morethan3 seconds, you can cancel the running program
and select ot her p rograms ( see t he s ectio n ent itled " Sta rting a wa sh cy cle. . . " ).
Wh en y ou select I ntensi ve/Heav y/Nor mal Programs, you can select the 3in1 func tion.
1
2
3