Witheachwashcycle.
Compartment
For pro gramm es with pre-wash only.
(Follow the user instr uctions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indica tor on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the d ishwashe r has run.
Check the regeneration
salt level
Load the baskets
Select a p rogramme
Close the door , turn on the water tap and press the Start/reset button. The machine will start working
after about 10 seconds.
Runni ng the dishwasher
Switch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent disp enser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utens ils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower b asket.
Changing the programm e
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Refer to the dishwasher loading instructions.
Press the Programme button until the selected programme lights up .
( See the section entitled Operationg instruction )āā
When the working cycle has finishe d, the buzzer of the
dishwasher will sound 8 tim es, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Op en t he do or caref ull y.
Hot st eam may escape
when the door isopened!
If the appliance is switched off during a wash cycle, when switched
on again, plea se re-select the washing cy cle and opera te the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the On/Off button to switch on the appliance, Open the door.
1.Open the door a little to stop the dishwasher.
2.After the spray arm s stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door and press the start button, the dishwasher will start r u nning
again after 10 seconds.
For detailed operating method read the corresponding content on the instructio n manual.
1. A running cycle can o nly be modified if it has been running for a short time. Otherwise the deterg ent
m ay have already be en released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press programme button for more than 3 seconds to cancel the running programme.
3. Select a new programme .
To Next Page
Loading...
