Omega PL402XA - Dishwasher Installation Steps

6
5
7
2
RUBBER
SCREW
COVER
8
SCREW
CONE GEAR
6B
6A
【】Figure 7
Dishwasher installation steps
●
.
.
.
.
6
7
8
1 Install the furniture door to the outer door of the dishwasher using the brackets
provided. Refer to the template forpositioning o f the brackets.
2 Adjust the tension of the door springs by using an Allen key turning in a clockwise
motion totighten the left and right door springs. Failure to do this could cause damage
to your dishwasher (Illus tration 2)
3 Con nec t t he i nle t h ose to th e c old wat er s uppl y
4 Con nect t he d ra in hos e. Re fer t o d iagram (Figu re 6 )
5 Con nect t he p ower co rd
Affix the c ondensation strip under the work surface of cabinet.Please ensure
the condensation strip is flush with edge of work surface.
Plac e the dishwasher into position .
Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher
by t urn ing t he scre ws on th e le ft and r ight ha nd s ide of t he ca binet ( Illust rat ion 6A ).
To adjust the front feet, use a wrench and turn the front feet until the dishwasher is level
(Illust ration 6B).
9 The dishwasher must be secured in place. There are two ways to do th is:
A. Normal work surface-secure to the work surface by using two woodscrews e nsuring
the dishwasher weight is not being hit by the surface (Illustration 7).
B. Ma rble or gr anite wor k t op-se cure t he b ra cke t to the s ide pa nel of the d ishw asher
and secure the dishwasher to the furniture housing. Put the rubber cap over the scre w
(Illustration 8).