Omega PL403A - Protect against Freezing; Cleaning the Spray Arms; Cleaning the Door; Cleaning the Filter

The cont ro l p ane l can be clea ned by using a l ig htly dampened c loth.
Aft er cle aning, m ake sure to dry it tho roug hly.
For the e xteri or, us e a g ood applia nc e po lis h wax .
Never u se s harp objects, scouring pa ds o rh arsh c lea ners on a ny part o f the di shwasher.
Protect Against Freezing
1.Cut off the electrical power to the dishwasher.
2.Tur n off the water suppl y an d disco nnect the water inl et pi pe from the w ate r valve.
3.Drain the water from the inlet p ip e an d w ater valve. (Use a pan to gathe r th e water )
4.Reconnect the water inl et pi pe t o the wa te r val ve.
5.Remove t he f ilter at t he bott om of the tub and use a spong e to soak up wate r in the sum p.
pl ease t ake fros t prot ection meas ures o nt he dishwasher in winter. Ev ery fter washi ng c ycle s,
pl ease operate as follow s
time a
：
Cleaning the Filter
Cleaning The Door
To clean th e co a rse f ilter and t he fi n e filter, use a cleani n g brush. Reas sembl e the f ilter part s as sho wn in t h e f i gur es
on t h e la st pa ge a nd r eins ert t he e ntire assem bly in the dis hwa sher, po sitio ning it i n i ts s eat and pres sing dow nwa rds .
When c le aning the filters, don't knock on them. Otherwise, the filters could b e
contorted andthe performance ofthe dishwashercould be decreased.
To cle an th ee dge around t he door, you sho uld u se o nly a soft wa rm, dam p clot h.
To avoi d pene trat ion o f wa ter in to t he door lock and el ectrical component s, do not
use a spr ay c leaner of any k ind.
Never u se a spr ay c leaner t ocl ean t he d oor pan el as it m ay dam age the door loc k
and electrical components.
Abr asive ag ents o r some paper towels s hou ld not b e use d b ecau se o f the ri sk o f
scrat c hing or leaving spots on the stainless st eel s urf a ce.
Cleaning the Spray Arms
I f your dis hwasher cannot work beca use of t he ice,
pl ease con tact professi onal service person s.
It is necessary to c lean th e sp r ay a rms reg ul arl y f or hard
water chemicalswill clogthe sprayarm jetsandbearings.
- Ins pect the filter s for blo ckin g a fter e ver y time th e dis hwa sher ha s been us ed.
- By uns crewing t he c oar se fi lter, you can r em ove t he filter syst em . Re mov ea ny foo d re mna nts and
cleanthe filters underrunning water.
Remarks:
The entire filter assembly should be cleaned once a week.
To remove thelowerspray arm, pull out the spray arm upward.
To re m ov e th e upper s p ray a rm, h o ld t he n ut, r ota t e th e a rm
clockwise toremoveit.
Wash the arms in soap y an d warm wat er an d use a soft brus h to
clean the jets. Repl ac e th em aft er ri nsing the m th oroughly.