Tension adjustment
of the door spring
【】Figure5
Tension adjustment of the door spring
●
Connection of drain hoses
●
The door springs are set at the factory to the proper tension for the outer door.
If a est het ic w oode n pa nel a re i nst alle d, y ou wi ll hav e to ad jus t t he do or spr ing t ens ion.
Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable
(see figure 5).
D oo r sp ri ng ten si on i s c orr ect wh en
the door remains horizontal in the
fully o pened position yet rises
toaclosewiththeslightliftofa
finger.
，
Insert t he drai nh ose into a d rain p ipe with a m inimum diam eter of 4 0mm , or let i t run into the sink, mak ing sure t o
avoid bendingor crimping it. The topof the hosemust be lessthan 1000mm.
A
Counter
Front
Drain pipe
NOTE
The top of the hose
must be less than
1000mm.
φ 40 mm
B
To Next Page
Loading...
