10356610_V_1_0.DOC
22/23
Midi-section
Press and hold the Store/Midi -button for 3 seconds and the device enters the Midi-mode. In order to leave
the Midi-mode Modus, press and hold the Store/Midi -button for 3 seconds.
CLEANING AND MAINTENANCE
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse and the battery. Maintenance and service
operations are only to be carried out by authorized dealers.
In order to replace the battery please refer to "Inserting/exchanging battery".
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Please note: Please use 125 mA fuse for 230 V versions and 315 mA fuse for 115 V.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
To Next Page
Loading...