OMP Hobby Edge 540 - Page 12

ElevatorAssembly
Ø HorizontalTailInstallation
5. Aftertheglueisdried,assembletheservoarmand
controlhornwithballheadpullrod,securethecuphead
hexagonalscrew,gasket,ballheadtotheservoarm,
secureitwithironpliers,adjusttheballheadpullrodsto
properlength.
6. Securescrew,washer,ballheadtocontrolhorn.
7. Checktheanglebetweentheservoarmandcontrolarm.
(Makesurethecontrolhornisat90degreesagainst
servo.)
ZhuhaiEdgeSmartDriveTechnologyCo.,Ltd.
www.omphobby.com