12
Cleaning and daily disinfecting
Observe the rules below when cleaning or disinfecting parts. Failure to
observe these rules may result in damage, inefficient nebulization or
infection.
Carefully wash your hands before cleaning and disinfecting the nebulizer
parts.
Clean and disinfect the Nebulizer Kit and its parts and accessories
(Masks, Mouthpiece and Adapter) before using them as follows:
- the first time after purchase (cleaning and disinfection)
- if the device has not been used for a long period of time (cleaning and
disinfection)
- if another person uses the same device (cleaning and disinfection)
- after each use (cleaning)
- after the last treatment of the day (cleaning and disinfection)
Ɣ Cleaning the Nebulizer Kit, Masks, Mouthpiece (including all parts)
and Adapter:
Fully disassemble the nebulizer kit. Remove the valves from the
mouthpiece. Wash the parts in warm water and mild, neutral detergent.
Rinse them thoroughly with clean hot tap water, gently tap to remove
excess water and allow to air dry in a clean place. It is advisable to
replace the Nebulizer Kit and Mouthpiece after some 100 to
120 treatments or after about 20 boiling cycles.
Ɣ Cleaning the Compressor:
Make sure that the power plug is unplugged from the power outlet.
Wipe clean with a soft cloth moistened with water or mild, neutral
detergent.
Ɣ Removing condensation from the Air Tube:
If moisture remains in the air tube, follow the procedure described below.
Make sure that the air tube is connected to the compressor. Disconnect
the air tube from the nebulizer kit. Turn on the compressor and dry the air
tube by passing air through it.
To Next Page
Loading...
Need help?
General
