13
EN
Ɣ Disinfecting the Nebulizer Kit, Masks, Mouthpiece (including all
parts) and Adapter:
If the parts are heavily stained, replace them with new ones. The Nebulizer
Kit, Masks, Mouthpiece (including all parts) and Adapter can be disinfected
by using a chemical disinfectant such as ethanol, sodium hypochlorite
(Milton), following product instructions and rinsing off with clean warm
water. Leave to air-dry.
Note: Never clean with benzene, thinner or a flammable chemical. The
(non-latex) elastic bands cannot be disinfected. Remove them
when disinfecting the masks.
Ɣ Boiling:
The Nebulizer Kit, Mouthpiece (including all parts), Masks and Adapter
can also be disinfected by boiling between 15 to 20 minutes in plenty of
water. After boiling, carefully remove the parts, shake off excess water
and allow to air-dry in a clean environment.
Note: Do not boil the Air Tube.
Changing the air filter
If the air filter has changed color, or has been
used for more than 60 days, replace it with a
new one. To purchase the filters – see Other
Optional/Replacement Parts section.
Remove the air filter cover using a flat
screwdriver as shown in figure; remove the
filter and fit the new filter as shown.
Put the air filter cover back in place.
Note: Do not wash or clean the air filter. If the air
filter becomes wet, replace it.
Damp air filters can cause blockages
To Next Page
Loading...
Need help?
General
