Appendix A-2 Condition flag operations
Conversion: *** = same condition fla
eration differs, - = Different condition fla
eration, None = no corres
eration of CJ1M/CJ1G/CJ2M No "/" = Same o
eration in CQM1H and CJ
*= ON/OFF de
on the instruction statuus
CJ1M/CJ1G
Instructions CQM1H /CJ2M Conversion ER GT(>) GE
LT(<) LE(CJ) CY UF OF N (CJ)
Condition fla
= CQM1H does not have this settin
Interrupt control instructions
INTERRUPT CONTROL INT MSKS
MSKR
CLI
DI
None *
INTERVAL TIMER STIM MSKS
MSKR
None *
Step instructions
STEP DEFINE STEP STEP -
*
Basic I/O Unit instructions
I/O REFRESH IORF IORF -
*
7-SEGMENT DECODER SDEC SDEC *** *
7-SEGMENT DISPLAY OUTPUT 7SEG 7SEG
[Ver.2.0
or later
-*/
DIGITAL SWITCH DSW DSW
[Ver.2.0
or later
-*/
TEN KEY INPUT TKY TKY
[Ver.2.0
or later
-*/
HEXADECIMAL KEY INPUT HKY HKY
[Ver.2.0
or later
-*/
IO COMMAND TRANSMISSION IOTC
-
None *
Serial communications instructions
PROTOCOL MACRO PMCR PMCR *** *
TRANSMI
TXD TXD *** *
RECEIVE RXD RXD *** *
CHANGE SERIAL PORT SETU
STUP STUP *** *
Network instructions
NETWORK SEND SEND SEND *** *
NETWORK RECEIVE RECV RECV *** *
DELIVER COMMAND CMND CMND *** *
Display instructions
MESSAGE MSG MSG *** *
Clock instructions
HOURS TO SECONDS SEC SEC *** * *
SECONDS TO HOURS HMS HMS *** * *
Debugging instructions
TRACE MEMORY SAMPL
TRSM TRSM ***
Failure diagnosis instructions
FAILURE ALARM AND RESE
*
SEVERE FAILURE ALARM FALS FALS -
FPD FPD *** *
*
Other instructions
SET CARR
CLC CLC ***
OFF
High-speed counter/pulse output instructions
MODE CONTROL INI INI *** *
HIGH-SPEED COUNTER PV READ PRV PRV *** *
ON/OFF
depending on
instruction
operation
(CJ2M only)
COMPARISON TABLE LOAD CTBL CTBL *** *
SET PULSES PULS PULS *** *
SPEED OUTPUT SPED SPED *** *
ACCELERATION CONTROL ACC ACC *** *
PULSE OUTPUT PLS2 PLS2 *** *
PULSE WITH VARIABLE DUTY FACTO