Need help?Do you have a question about the Omron CJ2M-CPU33 and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Manufacturer | Omron |
| Model | CJ2M-CPU33 |
| High-speed Processing | Yes |
| Power Supply | 24 VDC |
| Operating Temperature | 0 to 55 °C |
| User Memory | 128 KB |
| I/O Capacity | 2560 points |
| Humidity | 10 to 90% RH |
| Vibration Resistance | 10 to 57 Hz, 0.075 mm amplitude, 57 to 150 Hz, 9.8 m/s² acceleration |
Lists the specific OMRON devices compatible with the connection guide.
Details the hardware components and their interconnections for the setup.
Lists the required parameter settings for PLC and Sensor Controller communication.
Explains connector configurations and pin assignments for serial communication cables.
Outlines the overall steps for connecting the PLC to the Sensor Controller.
Details methods to verify that serial communication is performing normally.
Provides instructions for setting up the Sensor Controller hardware and parameters.
Details the setup procedures for the PLC, including project file handling and I/O table creation.
Explains how to initialize the PLC settings, including CPU and Serial Units.
Details the procedure for initializing the settings of the Serial Communications Unit.
Guides on initializing the CPU Unit settings by clearing memory areas.
Refers to another manual for Sensor Controller initialization procedures.
Explains program overview, connection procedures, and PMCR instruction.
Covers communications sequence, data format, error detection, and processing.
Shows memory maps, address allocations, and details of the ladder program.
Explains protocol macro data composition, settings, and timing.
To Next Page