17
EN
5. Cleaning and daily disinfecting
5.1 Cleaning
Following the cleaning instructions after each use will prevent any remaining
medication in the tank from drying, resulting in the device not nebulizing effectively
and also for preventing infections.
Warning:
Thoroughly rinse the nebulizer kit and the mask, nosepiece or mouthpiece
with clean hot tap water after each use, and disinfect the parts of the
nebulizer kit and applicable inhalation attachments after the last treatment of
the day.
Note: Do not start operation before the cleaned parts are completely dried.
1. Make sure that the power switch is in the (off) position.
2. Unplug the power cord from the electrical outlet.
3. Remove the nebulizer kit from the air tube and disassemble the nebulizer
kit. Refer to Section 3 (page 10-13).
4. Discard any remaining medication in the
medication tank.
5. Wash all the nebulizing parts in warm water and mild detergent and rinse in
clean hot tap water.
For instructions on how to disinfect the parts, see the following section.
6. After cleaning and disinfecting the parts, rinse them thoroughly with clean
water and allow the parts to air dry in a clean environment.
Care and maintenance
NE-C28P-E_main.book Page 17 Friday, October 7, 2011 2:48 PM
To Next Page
Loading...
Need help?
General
