2
E2C-EDA
Amplifier Units
Amplifier Units with Cables
Amplifier Units with Wire-saving Connectors (An Amplifier Unit Connector (sold separately) is required.)
Note: These models allow you to use an E3X-DRT21-S VER.3 Sensor Communications Unit. When using the E3X-DRT21-S VER.3, use an E3X-
CN02 Connector without a Cable for the Wire-saving Connector.
Amplifier Unit with Connector for EtherCAT or CompoNet Sensor Communications Units [Refer to Dimensions page 16]
Wire-saving Connectors (Order Separately)
Note: Protector seals provided.
[Refer to E3X-DA-S/MDA.]
Item Appearance Functions
Model
NPN output PNP output
Advanced models
Twin-output models
Area output, open
circuit detection,
differential operation
E2C-EDA11 2M E2C-EDA41 2M
External-input models
Remote setting,
differential operation
E2C-EDA21 2M E2C-EDA51 2M
Item Appearance Functions
Model
NPN output PNP output
Advanced models
Twin-output models
Area output, open
circuit detection,
differential operation
E2C-EDA6 E2C-EDA8
External-input models
Remote setting,
differential operation
E2C-EDA7 E2C-EDA9
Item Appearance Functions Model
Applicable Sensor
Communications Unit
Advanced model
Twin-output model
Area output, open
circuit detection,
differential operation
E2C-EDA0
E3X-ECT
E3X-CRT
Item Appearance Cable length No. of conductors Model
Master Connector
2 m
4 E3X-CN21
Slave Connector 2 E3X-CN22
Ordering Precaution for Amplifier Units with Wire-saving Connectors
A Connector is not provided with the Amplifier Unit.
Refer to the following tables when ordering.
When Using 5 Amplifier Units
Amplifier Unit
Applicable Connector
(Order Separately)
Model NPN output PNP output Master Connector Slave Connector
Advanced models
E2C-EDA6 E2C-EDA8
+ E3X-CN21 E3X-CN22
E2C-EDA7 E2C-EDA9
Amplifier Units (5 Units) + 1 Master Connector 4 Slave Connectors
To Next Page
Loading...
