Oil-resistant, Robust, Compact Photoelectric Sensor E3ZM-C 7
Sensing
method
BGS Reflective
Model NPN output
E3ZM-CL61H (-M1TJ)
E3ZM-CL66H
E3ZM-CL62H (-M1TJ)
E3ZM-CL67H
E3ZM-CL64H (-M1TJ)
E3ZM-CL69H
Item
PNP output
E3ZM-CL81H (-M1TJ)
E3ZM-CL86H
E3ZM-CL82H (-M1TJ)
E3ZM-CL87H
E3ZM-CL84H (-M1TJ)
E3ZM-CL89H
Sensing distance
10 to 100 mm
(White paper 100
× 100 mm)
10 to 150 mm
(White paper 100 × 100 mm)
10 to 200 mm
(White paper 100 × 100 mm)
Spot diameter
4-mm dia. at sensing distance of
100 mm
12-mm dia. at sensing distance of
150 mm
18-mm dia. at sensing distance of
200 mm
Standard sensing object ---
Differential travel 3% of sensing distance max. 15% of sensing distance max. 20% of sensing distance max.
Black/white error 5% of sensing distance max. 10% of sensing distance max. 20% of sensing distance max.
Directional angle ---
Light source (wavelength) Red LED (650 nm) Red LED (660 nm)
Power supply voltage 10 to 30 VDC, including 10% ripple (p-p)
Current consumption 25 mA max.
Control output
Load power supply voltage: 30 VDC max., Load current: 100 mA max. (Residual voltage: 2 V max.)
Open-collector output (NPN/PNP output depending on model)
Light-ON/Dark-ON cable connection selectable
Protection circuits
Reversed power supply polarity protection, Output short-circuit protection, Reversed output polarity protection,
Mutual interference protection
Response time Operate or reset: 1 ms max.
Sensitivity adjustment ---
Ambient illumination
(Receiver side)
Incandescent lamp: 3,000 lx max., Sunlight: 10,000 lx max.
Ambient temperature range Operating: −25 to 55°C, Storage: −40 to 70°C (with no icing or condensation)
Ambient humidity range Operating: 35% to 85%, Storage: 35% to 95% (with no condensation)
Insulation resistance 20 MΩ min. at 500 VDC
Dielectric strength 1,000 VAC, 50/60 Hz for 1 min
Vibration resistance Destruction: 10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions
Shock resistance Destruction: 500 m/s
2
3 times each in X, Y, and Z directions
Degree of protection * IEC: IP67, DIN 40050-9: IP69K
Connection method
-CL@@1H/-CL@@2H/-CL@@4H: Pre-wired cable (standard length: 2 m, -M1TJ: Pre-wired connector with 0.3-m
cable)
-CL@@6H/-CL@@7H/-CL@@9H: M8 4-pin connector
Indicator Operation indicator (yellow), Stability indicator (green)
Weight
(packed
state)
Pre-wired
models
Approx. 90 g (-M1TJ: Approx. 50 g)
Connector
models
Approx. 40 g
Materials
Housing SUS316L
Cable Oil-resistant vinyl cable
Lens PMMA (polymethylmethacrylate)
Display PES (polyethersulfone)
Seals Fluoro rubber
Accessories Instruction sheet (Note: Mounting Brackets are sold separately.)
To Next Page
Loading...
