E5CC-800/E5CC-B-800/E5CC-U-800
11
E5CC-B-800 (Push-In Plus Terminal Blocks)
Note: 1. The application of the terminals depends on the model.
2. Do not wire the terminals that are shown with a gray background.
3. When complying with EMC standards, the cable that connects the sensor must be 30 m or less.
If the cable length exceeds 30 m, compliance with EMC standards will not be possible.
4. Refer to Wiring Precautions for E5
@
C-B (Controllers with Push-In Plus Terminal Blocks) on page 65 for wire specifications and wiring
methods.
5. Common terminals are indicated with asterisks (*). You can use the input power supply and communications common terminals for
crossover wiring. Do not exceed the maximum number of Temperature Controllers given below if you use crossover wiring for the input
power supply.
100 to 240 VAC Controllers: 16 max.
6. Due to UL Listing requirements, use the E54-CT1L or E54-CT3L Current Transformer with the factory wiring (internal wiring).
Use a UL category XOBA or XOBA7 current transformer that is UL Listed for field wiring (external wiring) and not the factory wiring
(internal wiring).
23
19
22
1
2
17
18
3
15
24 16
6
8
9
14
215 13
204 12
11
10
7
8
6
7
8
7
88
Pt
A
B
B
+
-
m
-
+
7
6
V
-
7
V
+
6
TC
6
I
13
14
15
16
9
10
11
12
*
*
*
100 to 240 VAC
Auxiliary output 2
Auxiliary output 1
(2) Auxiliary Outputs
(3) Input Power Supply
(5) Sensor (Temperature/Analog) Input
(6) Options
OUT1
R
1
2
RX
Models with
1 Relay
Output
(1) Control outputs 1
2
-
+
1
OUT1
C
CX
Models with 1
Linear Current Output
Relay outputs
outputs: 250 VAC, 2 A
(resistive load)
Auxiliary outputs 1, 2
+
1
2
-
OUT1
Q
QX
Models with 1
Voltage Output
(for Driving SSR)
The E5CC is set for a K-type thermocouple
(input type = 5) by default. An input error
(s.err) will occur if the input type setting does
not agree with the temperature sensor. Check
the input type.
E5CC-@@ 2 @ B M - 8@@
(1) (2)
(3) (4)
(5)
(6)
↑
Terminal type
Control output 1
Relay output
250 VAC, 3A
(resistive load)
Voltage output
(for driving SSR)
12 VDC, 21 mA
B(+)
A(-)
RS-485
17
18
19
20
21
22
23
24
*
*
804
Communications
(RS-485), and
Event Inputs 3 and 4
*
EV4
EV3
(-)
(-)
CT1
B(+)
A(-)
RS-485
17
18
19
20
21
22
23
24
*
*
802
Communications
(RS-485), CT1
13
14
15
16
To another E5@C
Wiring Example:
To Next Page
Loading...
Need help?
General
