Component Names and Functions
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(K)
(L)
(J)
Connector name Description
(A) SD memory card
installation con-
nector
Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be af
fected or data
may be destroyed.
(B) Ethernet connec-
tor
Connect an Ethernet device.
FH-1050/FH-3050
FH-1050-10/-20, FH-3050-10/-20
FH-2000/5000 series
Upper port :
Ethernet port
Lower port :
Ethernet port,
EtherNet/IP port, and
PROFINET port are
sharing use.
Ethernet port,
EtherNet/IP port, and
PROFINET port are
sharing use.
(C) USB connector Connect a USB device.
Do not plug or unplug it during measurement. Otherwise measurement time may
be af
fected or data may be destroyed.
FH-1000/FH-3000 series
All ports: USB2.0
FH-2000/FH-5000 series
Left ports: USB2.0
Right ports: USB3.0
The USB3.0 interface has a
higher bus power supply
capability than the USB2.0
interface, and you can
expect more stable
operation with it.
Also, when used in combination with a
USB3.0 device, you can expect higher
transfer speed than USB2.0.
Be sure to give priority to using the USB3.0
interface.
(D) RS-232C connec-
tor
Connect an external device such as a PLC.
(E) DVI-I connector Connect a monitor.
(F) I/O (Parallel) con-
nector (control
lines, data lines)
Connect the controller to external devices such as a sync sensor and PLC.
3 Configuration
3-11
FH Series Vision System Hardware Setup Manual (Z366-E1)
3-1 Sensor Controller
3
3-1-1 FH-1000/2000/3000/5000 Series
To Next Page
Loading...