Omron G9SX Series - G9 SX Accessories and Specifications; Specifications

6
G9SX
Accessories
Terminal Block
Note: The G9SX main unit comes with a terminal block as standard equipment. The accessories shown here can be ordered as a replacement.
* The illustrations show 3-pin types
Specifications
Ratings
Power input
* Power consumption of loads not included.
Inputs
* Provide a current equal to or higher than that of the minimum applicable load of the connected input control device.
Outputs
*1. While safety outputs are in the ON state, the following signal sequence is output continuously for diagnosis. When using the safety outputs as
input signals to control devices (i.e. Programmable Controllers), consider the OFF pulse shown below.
*2. The following derating is required when Units are mounted side-by-side.
G9SX-AD322-@/G9SX-ADA222-@/G9SX-BC202-@: 0.4 A max. load current/output
*3. A load current below 1 A DC/output can be used when the following outputs are used.
G9SX-AD322-@/G9SX-ADA222-@: 2 outputs or less
G9SX-BC202-@: 1 output
Expansion Unit Ratings
Appearance * Specifications Applicable units Model Remarks
Terminal Block with screw
terminals (3-pin)
G9SX-AD-@
G9SX-ADA-@
Y9S-03T1B-02A
Two Terminal Blocks (black) with screw
terminals, and a set of six code marks to
prevent erroneous insertion.
Terminal Block with screw
terminals (4-pin)
G9SX-BC-@
G9SX-EX-@
Y9S-04T1B-02A
Two Terminal Blocks (black) with screw
terminals, and a set of six code marks to
prevent erroneous insertion.
Terminal Block with spring-
cage terminals (3-pin)
G9SX-AD-@
G9SX-ADA-@
Y9S-03C1B-02A
Two Terminal Blocks (black) with spring-cage
terminals, and a set of six code marks to
prevent erroneous insertion.
Terminal Block with spring-
cage terminals (4-pin)
G9SX-BC-@
G9SX-EX-@
Y9S-04C1B-02A
Two Terminal Blocks (black) with spring-cage
terminals, and a set of six code marks to
prevent erroneous insertion.
Item Model G9SX-AD322-@/ADA222-@ G9SX-BC202-@ G9SX-EX-@
Rated supply voltage 24 VDC
Operating voltage range −15% to 10% of rated supply voltage
Rated power consumption * 4 W max. 3 W max. 2 W max.
Item Model G9SX-AD322-@/ADA222-@ G9SX-BC202-@
Safety input
20.4 VDC to 26.4 VDC, internal impedance: approx. 2.8 kΩ *
Feedback/reset input
Item Model G9SX-AD322-@/ADA222-@ G9SX-BC202-@
Instantaneous safety output *1
OFF-delayed safety output *1
P channel MOS-FET output
Load current:
0.8 A DC max./output *2 *3
P channel MOS-FET output
Load current:
0.8 A DC max./output *2 *3
Auxiliary output
PNP transistor output
Load current: 100 mA max./output
Item Model G9SX-EX-@
Rated load 250 VAC, 3 A/30 VDC, 3 A (resistive load)
Rated carry current 3 A
Maximum switching voltage 250 VAC, 125 VDC
ON
OFF
360 μs max.
Approx. 100 ms