C-160
Cam Positioner
H8PS
Multiple outputs (OUTPUT 1 to 8) can be connected to operate a load as shown below.
■
Connection Examples
TACHOMETER Connection
Since the rotational output consists of 60 pulses per revolution,
select an appropriate rpm meter.
RUN OUT Connection
The output is ON during run and test modes and can be used as a
status signal by connecting to the Input Unit of a Programmable Con-
troller (SYSMAC) or similar device.
Timing Chart
H8PS-8B/8BF H8PS-8BP/8BFP
Load
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Output 1
Output 2
Output 3
Load
12 34
−(13)
H7ER-N
H8PS-8B, -8BF
Tachometer output (9)
To Next Page
Loading...
