Need help?Do you have a question about the Omron H8PS and is the answer not in the manual?
General| Brand | Omron |
|---|---|
| Model | H8PS |
| Category | Valve Positioners |
| Language | English |
Introduction to the H8PS Cam Positioner as an electronic cam switch.
Details on basic and advanced functions, models, resolution, and speed capabilities.
Diagrams showing system setup for 8-output and 16-/32-output models.
Overview of available H8PS Cam Positioner models based on output, mounting, and configuration.
Identification and description of displays and operation buttons for different models.
Guidance on selecting appropriate encoders and output cables for the system.
Dimensions and mounting methods (flush and surface) for H8PS Cam Positioner units.
Dimensions, mounting diagrams, and accessories for different encoder models.
System connection diagrams, terminal arrangements, and output cable connections.
Explanation of the H8PS Cam Positioner's operation modes: Programming, Test, and Run.
Step-by-step guide for initial setup, including encoder selection, origin setting, and cam programming.
Instructions for configuring encoder resolution and rotation direction using DIP switches.
Procedure for designating the machine's origin to match the encoder's origin.
Methods for setting ON/OFF angles using manual key input or teaching mode.
Steps to verify the operation timing in Test mode after setting ON/OFF angles.
Instructions for starting normal operation in Run mode, including start input requirements.
Methods for clearing individual settings (steps, cams, banks) or all programmed data.
Procedure for checking programmed ON/OFF angles and settings while the unit is in Run mode.
How to toggle the display information between rotational speed and angle.
How to enable the all protection function to disable all operations during Run mode.
Overview of transitions between Programming, Test, Run, and Function Setting modes.
Explanation and application of the ADV function for compensating output timing delays at high speeds.
How start input controls output status, prohibiting outputs when the start input is OFF.
Setting the number of output pulses and the pulse output start angle.
Functionality and allocation of upper and lower speed alarm limits to outputs.
Limiting the number of programmable steps per cam or for all cams.
Setting protection for individual cams to prevent program changes.
Managing multiple programs (banks) for different workpieces or setups.
Configuring the E24 error detection for disconnected encoders.
Detailed ratings and characteristics of the H8PS Cam Positioner and its components.
Common problems, probable causes, and corrective actions for self-diagnostic errors and operational issues.
Summary of switch settings, mode selections, and parameter configurations.
Diagrams illustrating timing relationships for start input, outputs, and bank switching.
Conversion table for displaying angles in 360° notation with a 256-resolution encoder.
Template for writing cam programs and documenting settings.
To Next Page
