Omron H8PS - 3.6 Checking the Operation Timing

Section 3 HOW TO USE THE BASIC FUNCTIONS
3-12
HOW TO USE THE
BASIC FUNCTIONS
3.6 Checking the Operation Timing
Set the mode switch to TEST and check the ON/OFF angles while turning on the outputs.
Operating the machine (Encoder) to confirm the operation timing.
If it is not correct, change the set ON/OFF angles.
For the procedure to change the ON/OFF angles, refer to "3.5 Setting the ON/OFF Angles".
■ For 16-/32-output Models
Be sure to turn ON the start input. ("ST" will light on the display.)
Cam outputs and the RUN output are not turned ON unless the start
input is turned ON.
For details of operation chart, refer to "Appendix D Operation Timing
Chart".
PRGM
TEST
RUN