Omron HEM-630 - How to Take a Reading

10
How to Take a Reading
When it is ready to measure, take the measurement in the following procedure.
To start measurement, simply press the START/STOP button.
1. Press the START/STOP button.
(1) Press the START/STOP button.
Release the Button when
the display turns on.
(2) Initial display
All display symbols turn
on for about 0.5 seconds.
* The battery replacement mark
shown here does not mean the
worn batteries.
(3) Deflation display
A mark starts to flash.
(4) The monitor starts to inflate
and measure.
* Because measurement is made
during inflation, do not move
your hand, wrist, or arm after
the monitor starts to inflate.
SYS mmHg
DIA mmHg
PULSE/min
These marks disappear
one by one as the
measurement proceeds.