13
Memory Feature
2. Press the START/STOP button to turn off the power.
After reading the blood pressure values
and pulse rate stored in the monitor,
press the START/STOP button
to turn off the power.
* Even if you forget to turn off the power, the monitor will turn off
automatically in approximately 2 minutes.
* The stored measurements will remain in the memory even when
The batteries are removed for battery replacement.
• To delete the memory (Everything in the memory will be deleted.)
Press the "M" button while the "M"
mark is displayed, then immediately
hold down the START/STOP button
for more than 2 seconds. (Pressing
the START/STOP button first will
turn off the power.)
Release the START/STOP button when
the "M" mark starts to flash and wait
until it finishes to flash.
To Next Page
Loading...
