Omron HEM-7320T-CACS - Performing Standalone Measurements; Starting and Completing Measurement

21
3. Using Your Monitor without a Smart Device
EN
2. Press the [START/STOP] button.
The monitor automatically starts to inflate.
3. Remove the arm cuff.
4. Press the [START/STOP] button to turn the monitor off.
The monitor automatically stores readings in its memory.
It automatically turns off after 2 minutes.
NOTE: Wait 2-3 minutes before taking another measurement. Waiting between measurements allows
the arteries to return to the condition prior to taking a measurement.
START INFLATING DEFLATING COMPLETED
What to do if your systolic
pressure is more than 210 mmHg
After the arm cuff starts to inflate, press and
hold the [START/STOP] button until your
monitor inflates 30 to 40 mmHg higher than
your expected systolic pressure.
NOTE: The monitor does not inflate above
299 mmHg.
Inflating to a higher pressure than
necessary may result in bruising where
the arm cuff is applied.