6. Push the START Button to start the
measurement.
• Do not push the START Button without wrapping the
cuff on the arm.
If a pulse rate is detected during deflation, the pressure
display will be synchronized with the pulse rate and
renewed.
• If you want to inflate again after the start of deflation,
you can inflate the monitor again by pushing the START
Button only while you are pushing it.
• If you want to accelerate deflation after the start of
deflation, you can accelerate it by pushing the
DEFLATION (deflation control) / Measurement Results
Display Switch Button. Each time the Button is pushed,
the deflation speed can be accelerated by
approximately 5 to 10 mmHg.
7. Push the STOP Button to finish the
measurement.
• While the battery pack is in use, the monitor will turn off
automatically in approximately five minutes and the
display (measurement results) will disappear.
(Automatic Power Off)
If the monitor detects a noise during the
measurement or determines that the
pressure value is not correct, an error display
appears (Er1 to 9). In this case, refer to Page
24 for the remedial actions and start the
measurement again.
HEM-907-draft(Eng) 9/21/00 4:08 PM Page 21