Do not use a cellular phone near this unit.
• This unit may malfunction.
Do not use this unit in a moving vehicle.
• This may result in erroneous measurement.
Do not install parts and/or instrument that are not specified for this unit.
• It may cause damage to the unit.
Do not use broken power cord or AC adapter, or loose electric outlet.
• There is danger of electric shock, or there may be short circuit or fire
ignition.
Do not pull the power cord when unplugging the AC adapter from the electric
outlet.
• The power cord will be disconnected or short-circuited, and may cause fire
or you may suffer electric shock.
Do not scratch, damage, modify, forcibly bend, pull, twist, bundle the cord of
AC adapter, or place heavy materials on it, or pinch it.
• You may suffer electric shock or there may be electric leak and fire because
of deteriorated insulation.
Do not install or store this unit where it may be sprayed with water or
medication.
• There is danger of electric shock.
General advice
Do not place or put anything on this unit.
Do not apply strong shock to or drop this unit.
Turn off power and unplug the AC adapter from the electric outlet before moving the unit.
Read the instruction manual of the other devices to be used at the same time with this unit, to
understand and be aware of the interaction between the devices.
Before using the unit
• Check if all cords and tubes are securely connected.
• Operate the Buttons to check that this unit operates normally before use.
When using the unit
• Do not inflate the cuff without being wrapped over the arm.
• Do not use torn cuff.
• Be sure that the patient do not touch the Buttons of this unit.
After using the unit
• Clean and store this monitor and accessories.
• Do not clean this unit with gasoline, paint thinner, or high concentration alcohol.
• Do not disinfect this unit by autoclave or gas sterilization (EOG, formaldehyde, or high
concentration ozone).
Do not install or store this unit in the following places.
• Under direct sunlight
• Dusty or salty environment
• At an inclined position, or subject to vibration and/ or shock
• Storage of chemicals or where gas may be generated
• At high temperature and high humidity
HEM-907-draft(Eng) 9/21/00 4:07 PM Page 3
To Next Page
Loading...
Need help?
General
