RELIEVE
SHLDR
SOLE
LEG
WAIST
TAP
KNEAD PUSH RUB
REGION
MASSAGE
POINT
WIDE
R
SPECIAL
MODE
REPEAT
SOFT
OFF
INTENSITY
/POWER
W
ELECTRONIC
PULSE MASSAGER
11
How to Treat
This section explains the treatment procedure and the entire operation flow from turning on the power
to storing of the unit.
Three treatment methods are available. Select your favourite one to receive treatment.
– Treat with the Relieve Button
When you want to relieve pain.
– Treat with the Region Button
When you want to treat the selected region of shoulder, sole, leg (calf), and waist (lower back) with the
program.
– Treat with the Massage Button
When you want to treat the region according to your symptom and favourite operation by selecting the
massage method from Tapping, Kneading, Pushing, and Rubbing.
Have you connected the Electrode Cord? (Refer to Page 8.)
Have you attached the Pads to the regions you want to receive treatment? (Refer to Page 9.)
1. Turn on the power.
Rotate the Intensity Adjustment/Power Dial Switch downwards.
When you hear a click, the power is turned on and the treatment
starts.
❇ When you use the unit for the first time, the Shoulder light and the
WIDE light will flash. When you use the unit for the second time
and after, the Buttons you used in the previous treatment
will flash.
2. Select one treatment method.
– Treat with the Relieve Button (Refer to Page 13.)
– Treat with the Region Button (Refer to Page 14.)
– Treat with the Massage Button (Refer to Page 15.)
If the Pads come off:
If the Pads come off from the skin, the power will be turned off
automatically in approximately 7 seconds. Turn the Power to OFF,
then re-attach the Pads correctly and turn on the power again.
Click
To Next Page
Loading...
Need help?
General
