Add ID-40s as EtherNet/IP Devices
13. Add ID-40s as EtherNet/IP Devices
13.1. In the Toolbox, click the + button to add the ID-40s as EtherNet/IP devices, as shown below.
13.2. Enter the IP address for the rst ID-40, which in this example is 192.168.250.11. Click the "Model name"
dropdown menu and select MicroHAWK ID-40. In the Revision dropdown select 1. When completed it
should resemble the image below. Click the + button, which is found at the bottom of the Toolbox dialog.
20
Technical Note: MicroHAWK ID-40 360
º
Barcode Reading Solution
TECHNICAL
NOTE
To Next Page
Loading...
